Invicta
Invicta Pro Diver Strap Size — 20mm Lug Width
The Invicta Pro Diver has a 20mm lug width, so it takes a 20mm watch strap.
Lug width20mm
| Lug width | 20 mm |
|---|---|
| Case size | 40 mm |
| Lug-to-lug | 48 mm |
| Thickness | 13 mm |
| Spring bar Ø (typical) | 2.0 mm |
| End type | Straight |
Strap styles that fit
- NATO / Zulu20mm fits if the strap's thickness clears the case under the bars.
- PerlonWoven pass-through, 20mm.
- 2-piece leatherStraight ends fit flush.
- Rubber / siliconeDivers & sports fit well.
- Milanese / meshStraight-end 20mm mesh fits.
- Metal braceletNeeds 20mm end-links shaped for this case.
▲ Sub-homage; 20mm.
Fit & sizing notes for the Pro Diver
- Width: buy 20mm straps. Tapered straps listed as 20/18mm or 20/16mm fit too; only the first number has to match. See strap sizes explained.
- Spring bars: 20mm long, about 2.0mm diameter (spring bar sizes).
- Wrist fit: at 48mm lug-to-lug it should sit within the top of wrists from about 16.0cm up (rule of thumb: lug-to-lug under ~30% of wrist size). That's longer than 62% of the watches in our index. See what size watch suits your wrist.
- Strap thickness: at 13mm thick it's a chunky case: thicker padded leather, rubber/FKM or a heavier NATO balance it visually; very thin straps can look undersized.
Sources & corrections
Lug width from widely published specifications. Case sizes and references vary, so measure your own watch if anything looks different.
Spec wrong for your watch? Send us a correction with your reference number.
Get the right strap
Links open Amazon — we may earn a commission at no cost to you.
Invicta Pro Diver — strap questions
What size strap does the Pro Diver take?
The Invicta Pro Diver has a 20mm lug width, so you need a 20mm watch strap.
Will any 20mm strap fit the Pro Diver?
Most will. Width is the main thing to match, but also check that the strap's spring-bar holes suit the bars, and that the strap is thin enough to clear the case between the lugs. A metal bracelet needs 20mm end-links made for this model.
What spring bar size does the Pro Diver use?
20mm long and about 2.0mm in diameter (a typical figure; measure the original bar to be sure).
Is the Pro Diver good for strap swapping?
Yes. With standard 20mm spring-bar lugs, NATO, leather, rubber and mesh straps can all be fitted with a spring-bar tool.