Seiko
Seiko Samurai Strap Size — 22mm Lug Width
The Seiko Samurai has a 22mm lug width, so it takes a 22mm watch strap.
Lug width22mm
| Lug width | 22 mm |
|---|---|
| Case size | 43.8 mm |
| Lug-to-lug | 47 mm |
| Thickness | 13.2 mm |
| Spring bar Ø (typical) | 2.5 mm |
| End type | Straight |
Strap styles that fit
- NATO / Zulu22mm fits if the strap's thickness clears the case under the bars.
- PerlonWoven pass-through, 22mm.
- 2-piece leatherStraight ends fit flush.
- Rubber / siliconePick straps with holes made for fat bars.
- Milanese / meshStraight-end 22mm mesh fits.
- Metal braceletNeeds 22mm end-links shaped for this case.
Fit & sizing notes for the Samurai
- Width: buy 22mm straps. Tapered straps listed as 22/20mm or 22/18mm fit too; only the first number has to match. See strap sizes explained.
- Spring bars: 22mm long, about 2.5mm diameter. These are fat bars, so pick straps with holes made for them, or swap to thinner 22mm bars for slim leather (spring bar sizes).
- Wrist fit: at 47mm lug-to-lug it should sit within the top of wrists from about 15.7cm up (rule of thumb: lug-to-lug under ~30% of wrist size). That's longer than 36% of the watches in our index. See what size watch suits your wrist.
- Strap thickness: at 13.2mm thick it's a chunky case: thicker padded leather, rubber/FKM or a heavier NATO balance it visually; very thin straps can look undersized.
Sources & corrections
Lug width checked against: WatchBase: SRPB51. Last checked 24 October 2026.
Spec wrong for your watch? Send us a correction with your reference number.
Get the right strap
Links open Amazon — we may earn a commission at no cost to you.
Seiko Samurai — strap questions
What size strap does the Samurai take?
The Seiko Samurai has a 22mm lug width, so you need a 22mm watch strap.
Will any 22mm strap fit the Samurai?
Most will. Width is the main thing to match, but also check that the strap's spring-bar holes suit the bars, and that the strap is thin enough to clear the case between the lugs. A metal bracelet needs 22mm end-links made for this model.
What spring bar size does the Samurai use?
22mm long and about 2.5mm in diameter (a typical figure; measure the original bar to be sure). These are thicker 'fat' bars, so heavier straps suit it best.
Is the Samurai good for strap swapping?
Yes. With standard 22mm spring-bar lugs, NATO, leather, rubber and mesh straps can all be fitted with a spring-bar tool.